How To Replace Bathroom Extractor Fan

Bathroom extractor fan checklist.

How to replace bathroom extractor fan. Bath fans vary in design but motor replacement requires the same basic steps no matter which brand or model you have. The bathroom is the most humid room so needs good ventilation. Lower the fan into place and secure it with drywall screws then use flexible duct pipes to vent the fan to the outside.

You can use the existing switch wires and ductwork. To replace a bathroom fan all you need to do is remove the old fan and install a new one in its place using the same wiring and connections. Some motor plates release by pressing or prying on the side of the fan housing.

Then ensure the power is switched off by using a voltage detector and disconnect the wiring to the fan. It is important to keep the level of condensation levels low in your kitchen bathroom and laundry room. To install a bathroom fan go into your attic and clear away the insulation where the fan will go then return to the bathroom and use a jigsaw to cut out the hole for the fan.

Turn off the power to the fan at the main breaker panel. Extractor fan fitting is simple if you are only replacing an existing unit and it can provide great results. This enables the fan to draw fresh air and operate far more efficiently.

Also it helps to get a fan that s the same size as your existing fan so you won t have to adjust the size of the ceiling hole. The installation is easiest if you re replacing an existing fan. Extractor fans do a great job of removing excess moisture in the air.

Replacing a noisy fan can be cheaper than repairing it. If your extractor fan is in need of replacement don t be distraught. The extractor or exhaust fan in a bathroom has a variety of uses including the removal of odour from the air and the removal of moisture from the bathroom.